Try Cisco : 300-110 practice torrent pass for sure

Cisco 300-110 Exam Overview:

Cisco 300-110 Exam Syllabus Topics:

Cisco Designing Cisco Wireless Networks Sample Questions:

1. A network engineer is preparing a predictive site survey for a new three-story office building before construction is complete. Which two inputs are required to produce an accurate predictive model? (Choose two.)

A) AP inventory serial numbers
B) wall and building material attenuation values
C) per-AP association counts from the existing network
D) spectrum analysis capture from each floor
E) scaled floor plans with correct dimensions

2. A company is upgrading its wireless infrastructure and is in a state of transition. Some parts of the company's building still run on the legacy WLC. The new WLC is not located at the same site as the legacy WLC. The company requires seamless client inter-controller roaming between the new WLC and the legacy WLC, with no disruptions. Both WLCs are separated by firewalls. Which troubleshooting command validates that the mobility control packets between the WLCs can be sent and received?

A) mapping mobility_peer IP address
B) debug mobility config enable
C) debug mobility handoff enable
D) mapping mobility_peer_management IP address

3. An engineer must design and configure a wireless network for pervasive coverage in an oil terminal, casual web and email traffic, 5 GHz. What is the best design?

A) Disable all data rates below 24 Mbps and keep the power assignment on the AP as auto.
B) Keep the power assignment as auto and disable 802.11n and 802.11ac MCS rate.
C) Disable all data rates below 54 Mbps and assign static power level 1 on all access points.
D) Keep all the data rates enabled and set the AP power assignment mode to auto.

4. An engineer must design AP placements for a new branch office that contains two floors. The engineer uses Ekahau to complete the predictive survey. To calculate the signal bleed through between floors, the engineer creates a building, adds the floors, and attenuation areas. After the scale is set, what else must be added on the floors to accurately measure the signal bleed at a specific location?

A) Draw in coverage areas.
B) Start the auto planner.
C) Choose the access point models.
D) Add alignment points.

5. A hospital has a Cisco Catalyst 9800 Series Wireless Controller in an SSO solution deployed in the primary data center. The hospital plans to increase redundancy in the wireless environment.
Management decides to deploy an extra Catalyst 9800 WLC offsite to another data center on a different subnet. A WAN link connects the data centers with a firewall at both ends. Which two design approaches must the engineer take to ensure that the APs can fail over? (Choose two.)

A) Create a static RF group leader on one of the wireless controllers.
B) Open UDP ports 16666 and 16667 between the wireless controllers.
C) Create a mobility tunnel between the wireless controllers.
D) Open HTTPS port 443 between the wireless controllers.
E) Create a mobility group with the same names on both wireless controllers.

Solutions: