Try Fortinet : FCNSA.v5 practice torrent pass for sure

In an IPSec gateway-to-gateway configuration, two FortiGate units create a VPN tunnel between two separate private networks.
Which of the following configuration steps must be performed on both FortiGate units to support this configuration? (Select all that apply.)

• A. Set the operating mode of the FortiGate unit to IPSec VPN mode.
• B. Define the Phase 2 parameters that the FortiGate unit needs to create a VPN tunnel with the remote peer.
• C. Define the Phase 1 parameters that the FortiGate unit needs to authenticate the remote peers.
• D. Configure the appropriate user groups on the FortiGate units to allow users access to the IPSec VPN connection.
• E. Create firewall policies to control traffic between the IP source and destination address.

Which of the following components are contained in all FortiGate units from the FG50 models and up? (Select all that apply.)

• A. Serial console port.
• B. FortiASIC content processor.
• C. Hard Drive.
• D. Gigabit network interfaces.

An end user logs into the full-access SSL VPN portal and selects the Tunnel Mode option by clicking on the "Connect" button. The administrator has enabled split tunneling.

Given that the user authenticates against the SSL VPN policy shown in the image below, which statement below identifies the route that is added to the client's routing table.

• A. A route to the destination matching the 'all' address object.
• B. A default route.
• C. A route to destination matching the 'WIN2K3' address object.
• D. No route is added.

In order to match an identity-based policy, the FortiGate unit checks the IP information. Once inside the policy, the following logic is followed:

• A. First, user restrictions are determined and port, time, and UTM profiles are applied. Next, a check is performed to determine if the user's login credentials are valid. Finally, the user is checked to determine if they belong to any of the groups defined for that policy.
• B. First, the user is checked to determine if they belong to any of the groups defined for that policy. Next, user restrictions are determined and port, time, and UTM profiles are applied. Finally, a check is performed to determine if the user's login credentials are valid.
• C. First, a check is performed to determine if the user's login credentials are valid. Next, the user is checked to determine if they belong to any of the groups defined for that policy. Finally, user restrictions are determined and port, time, and UTM profiles are applied.

When backing up the configuration file on a FortiGate unit, the contents can be encrypted by enabling the encrypt option and supplying a password.
If the password is forgotten, the configuration file can still be restored using which of the following methods?

• A. Having the password emailed to the administrative user by selecting the Forgot Password option.
• B. Selecting the recover password option during the restore process.
• C. Sending the configuration file to Fortinet Support for decryption.
• D. If the password is forgotten, there is no way to use the file.