Updated Jan-2022 Premium 500-220 Exam Engine pdf - Download Free Updated 58 Questions
Authentic 500-220 Dumps With 100% Passing Rate Practice Tests Dumps
NEW QUESTION 13
For which two reasons can an organization become "Out of License"? (Choose two.)
- A. MR licenses that do not match the MR models in the organization
- B. licenses that are in the wrong network
- C. expired device license
- D. licenses that do not match the serial numbers in the organization
- E. more hardware devices than device licenses
Answer: C,E
NEW QUESTION 14
Refer to the exhibit.
Which two actions are required to optimize load balancing asymmetrically with a 4:1 ratio between links? (Choose two.)
- A. Set the speed of the cellular uplink to zero.
- B. Enable load balancing.
- C. Add an internet traffic preference that defines the load-balancing ratio as 4:1.
- D. Change the assigned speeds of WAN 1 and WAN 2 so that the ratio is 4:1.
- E. Change the primary uplink to "none".
Answer: B,C
NEW QUESTION 15
What are two ways peers interact with ports that Auto VPN uses? (Choose two.)
- A. For IPsec tunneling, peers use high TCP ports within the 32768 to 61000 range.
- B. Peers contact the VPN registry at TCP port 9350.
- C. For IPsec tunneling, peers use UDP ports 500 and 4500.
- D. For IPsec tunneling, peers use high UDP ports within the 32768 to 61000 range.
- E. Peers contact the VPN registry at UDP port 9350.
Answer: A,E
Explanation:
Reference:
_Configuration_and_Troubleshooting
NEW QUESTION 16
How is high-availability supported for Cisco Meraki devices?
- A. The MX Security Appliances and MS Series Switches that use HSRP support an active/passive high- availability pair.
- B. Only the MX Security Appliances that use VRRP support high availability.
- C. An active/active high-availability pair is recommended for MX Security Appliances.
- D. The MX Security Appliances and MS Series Switches that use VRRP support an active/passive high- availability pair.
Answer: B
Explanation:
Reference:
_High_Availability_Pair
NEW QUESTION 17
Refer to the exhibit.
What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?
- A. The MX appliance performs data encryption for inter-VLAN traffic.
- B. The MX appliance performs AMP for inter-VLAN traffic.
- C. The MX appliance performs content filtering for inter-VLAN traffic.
- D. The MX appliance performs IDS/IPS for inter-VLAN traffic.
Answer: A
NEW QUESTION 18
What is the role of the Meraki Dashboard as the service provider when using SAML for single sign-on to the Dashboard?
- A. The Dashboard parses the SAML request and authenticates users.
- B. The Dashboard generates the SAML request.
- C. The Dashboard provides user access credentials.
- D. The Dashboard generates the SAML response.
Answer: B
NEW QUESTION 19
Which API endpoint clones a new Organization?
- A. PUT /organizations/{organizationId}/clone
- B. POST /organizations/clone/{organizationId}
- C. POST /organizations/{organizationId}/new
- D. POST /organizations/{organizationId}/clone
Answer: C
NEW QUESTION 20
How does a Meraki device behave if cloud connectivity is temporarily lost?
- A. The offline device reboots every 5 minutes until connection is restored.
- B. The offline device stops passing traffic.
- C. The offline device tries to form a connection with a local backup sever.
- D. The offline device continues to run with its last known configuration until cloud connectivity is restored.
Answer: C
NEW QUESTION 21
Which information is used to calculate whether a WAN link has high usage?
- A. value under Security & SD WAN > SD WAN & Traffic Shaping > Uplink Configuration
- B. total historical throughput of an uplink
- C. data under Security & SD WAN > Appliance Status > Uplink > Live Data
- D. total number of devices that are actively passing traffic
Answer: A
NEW QUESTION 22
Refer to the exhibit.
Which outcome occurs when logging is set to Enabled?
- A. Inbound flows are sent to a configured syslog server if a syslog server configured for flows.
- B. The hits counter within this section is now enabled.
- C. Outbound flows are sent to a configured syslog server if a syslog sender is configured for flows.
- D. This firewall rule is now enabled.
Answer: A
NEW QUESTION 23
Refer to the exhibit.
Which design recommendation should be considered?
- A. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
- B. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- C. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- D. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
Answer: D
NEW QUESTION 24
When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)
- A. Simultaneous logins
- B. RADIUS for splash page settings
- C. Captive Portal strength
- D. Firewall & traffic shaping
- E. Controller disconnection behavior
Answer: C,E
NEW QUESTION 25
Refer to the exhibit.
What are the Loss and Average Latency statistics based on?
- A. responses that the MX appliance receives on the connectivity-testing IP addresses on the Help > Firewall info page
- B. responses that the MX appliance receives on the connectivity-testing IP addresses on the Security & SD- WAN > Firewall page
- C. responses that the MX appliance receives on the connectivity-testing IP address that is configured on the Security & SD-WAN > SD-WAN & Traffic Shaping page
- D. responses that the MX appliance receives on the connectivity-testing hostnames on the Insight > Web App Health page
Answer: B
NEW QUESTION 26
What happens to an unsupervised iOS device when the "Meraki management" profile is removed?
- A. The "Meraki management" profile is removed and then pushed automatically by Systems Manager.
- B. The "Meraki management" profile cannot be removed.
- C. The "Meraki management" profile is removed. All configuration profiles that Systems Manager pushed are also removed.
- D. The "Meraki management" profile is removed. All configuration profiles that Systems Manager pushed remain.
Answer: C
NEW QUESTION 27
A customer requires a hub-and-spoke Auto VPN deployment with two NAT-mode hubs with dual uplink connections and 50 remote sites with a single uplink connection.
How many tunnels does each hub need to support?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 28
What is the best practice Systems Manager enrollment method when deploying corporate-owned iOS devices?
- A. DEP
- B. Apple Configurator
- C. Sentry enrollment
- D. manual
Answer: B
NEW QUESTION 29
Which two actions can extend the video retention of a Cisco Meraki MV Smart Camera? (Choose two.)
- A. enabling motion-based retention
- B. enabling audio compression
- C. installing an SSD memory extension
- D. configuring a recording schedule
- E. enabling maximum retention limit
Answer: A,D
NEW QUESTION 30
......
Cisco 500-220 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
| Topic 11 |
|
| Topic 12 |
|
| Topic 13 |
|
Verified Pass 500-220 Exam in First Attempt Guaranteed: https://www.suretorrent.com/500-220-exam-guide-torrent.html
Cisco 500-220 Real Exam Questions Guaranteed Updated Dump from SureTorrent : https://drive.google.com/open?id=1gGUw28D0HuGn9Bu0ni4kiO-tBF1MifAO